Miscea Remote Control, Instruction Manual

Page: 16 / 48

16
3. Use
4. Public-User Mode
3.12 Change the sound level of the beep tone
The sound level of the beep tone can be changed.
Press the «BEEP» button. Use the «+» and «-» buttons to switch between the 9
different sound level settings. To save settings, press the «SAVE» button. All colored
LED lights illuminate to indicate new setting has been saved. If «SAVE» button is not
pressed within 10 seconds of last selection, previously saved setting will be stored.
There are 9 settings available. Each setting is indicated with a different beep tone. For
miscea models with a display screen, this will also be indicated visually on screen.
Please see Fig. C - E for technical data.
3.13 Restore factory settings
The «DEFAULT» button can be used to restore the miscea system to factory settings.
To restore factory settings, press «DEFAULT». All colored LED lights will start blinking.
Press «SAVE» to finalize factory restore.
If the «SAVE» button is not pressed within 10 seconds of last selection, previously
saved setting will be stored. Please see Fig. C - E for technical data.
3.14 Replacing the battery
To replace the battery when it is out of power, see Fig. B01-B04.
4.1 Enable the Public-user Mode
The Public-user Mode is only available with miscea LIGHT systems with integrated
soap dispenser and from version V1.22 onwards.
The miscea LIGHT has a user mode for simplified use in public settings called the
’Public-user Mode’. The public user mode can be enabled on the miscea LIGHT system
by using the miscea remote control. To enable the public-user mode, please follow the
instructions below.
Press the buttons indicated in the below listed order. «LIQUID 2» button, «+» button,
«SAVE» button.
BEEP
DEFAULT
LIQUID 2
+