5
R0084055
29 June 18
C
US
60 Shorncliffe Rd., Toronto, Ontario M8Z 5K1
Telephone: (416) 231-9030 - Fax: (416) 231-0929
www.mirolin.com
Customer Service:
(416) 231-5790
Canada, U.S.A.: 1-800 -
MIROLIN
(647-6546)
Fax, Canada: 1- 800 - 463 - 2236
We want you to be completely satisfied with our products and service. If you have any comments or suggestions, please call
1-800-MIROLIN
toll free.
The company reserves the right to change models and specifications without notice.
Step 5:
Drill 3/16" holes along the flanges on each side.
Secure the tub shower into the alcove with screws
countersunk through the flange into the stud support as
shown. Note that over tightening or burying the head of the
screw will cause the acrylic to crack.
Note:
Ensure unit is plumbed before securing the
unit into the alcove.
Step 4:
Pull protective plastic film back around the joint
before reassembly. Reassemble the tub shower and fix
assembly with (14) latch locks released in steps 1- 3.
TESTING &
TROUBLE SHOOTING
"
Test the installation after completing the plumbing, but
before
enclosing
the
bath
and
finishing
the
surroundings.
"
Fill the bath with water and leave it for one hour to
ensure that the adjustment of the drain-overflow
assembly is correct, and that there are no leaks.
"
If water remains around the bath rim or drain: Check
that the installation is level and that the tub sits firmly
on its base; use wood shim to correct.
INSTALLATION CLEAN-UP
"
Remove construction dirt and residue with a mild liquid
detergent. DO NOT USE abrasive cleaners, scouring
compounds and pads, metal scrapers, steel wool, or
other materials that could damage or dull the surface of
the bath.
"
Remove plaster carefully with a blunt wooden block
having rounded edges.
"
Remove paint and other stubborn stains with isopropyl
(rubbing) alcohol.
"
DO NOT USE products such as acetone (nail polish
remover), dry cleaning solution, lacquer thinners,
gasoline, pine oil, etc.
FINISHING
"
Apply trim around the tub shower periphery to finish
drywall, if required.
"
Install the tub shower door according to the
manufacturer’s instructions if purchased.
Mirolin Industries Corp. is not responsible for any damages
incurred as a result of poor installation of the product.
MAINTENANCE
The acrylic sheet, which forms the surface of your bathtub,
provides one of the most durable surfaces found in modern
bathrooms. Keep it bright and smooth with mild liquid
household detergent, soap and water, or foaming
cleansers. NEVER USE aromatic solvents, abrasive
cleaners, scouring compounds or pads, strong liquid
cleansers, or other material that could damage or dull the
surface of the bath.
Restoring Surface Gloss
- Restore surface gloss by
applying a very fine rubbing compound and polishing the
surface by hand or with a power buffer. Finish with an
application of a good quality automotive wax.
Minor Repairs to Surface
- Remove minor scratches and
scuffs as follows. First, wet sand the area with 600 grit wet
sandpaper until the surface is smooth. Then, restore the
gloss as described under
RESTORING SURFACE
GLOSS.
Screws at 6"
Centre
Screw the Flange
to the 2"x4"stud
support
Drywall
Flange
Drywall
Note:
Remove the protective film from the tile
flange before fastening.