MIRKA CEROS325CV, Operating Instructions Manual

Page: 9 / 88

8 9
How to get started
Connect the power cord to the power supply unit and connect the other end to the mains supply. Connect
the DC plug of the sander to the power supply DC socket. Please look at Figure 1-2.
In order to take the full power out of this tool it is recommended to use it together with the Mirka
vacuum cleaner 412/415 or 912/915 and Mirka Net Sanding products. This makes the sanding work
very convenient and dust-free. The power supply can then be mounted on the vacuum cleaner with the
brackets kit MIN6519111.
The power cord from the power supply is in this application connected to the mains supply in the front of
the vacuum cleaner. This makes it possible to auto-start the vacuum cleaner when the lever on the sander
is pressed.
Operating Instructions
1) Make sure the sander is switched off. Select a suitable abrasive and secure it to the backing pad. Be careful
and center the abrasive on it. For optimal use of the machine we recommend a Mirka Net Sanding product.
2) Switch on the power supply unit with the On/Off switch Figure 2. The power supply LED is now green.
3) Switch on the sander by pressing the On/Off key Figure 1. The sander LED is now green.
4) The sander can now be started by pressing the lever.
5) The speed can be adjusted between the 4000 and max RPM by adjusting the position of the lever.
6) The max RPM can be adjusted by pressing the RPM+ or RPM- Figure 1. Every press adds or removes 1000 RPM
until it reaches the limits. The RPM can be adjusted in the range 4,000 to 10,000 RPM.
7) The tool has two modes of controlling the speed. In the default mode the speed can be adjusted linearly by
adjusting the position of the lever. In the other mode the speed is fixed to the adjusted max RPM always when
the tool is running. By pressing simultaneously both RPM+ and RPM- keys the tool toggles between the two
controlling modes.
8) When sanding always place the tool on the work surface then start the tool. Always remove the tool from
the work surface before stopping. This will prevent gouging of the work surface due to excess speed of the
abrasive.
9) When sanding is finished turn off the sander by pressing the On/Off key. The sander LED is now turned off.
NOTE! If the sander is used with an Interface it’s recommended to set the speed to max 7000 rpm
Disposal Information
Danger!
Disposal information for the old appliance! Render redundant power tools unusable by removing the
power cord. Only for EU countries. Do not dispose of electric tools together with household waste mate-
rial! In observance of European Directive 2002/95/CE, 2002/96/EC + 2003/108/CE on waste electrical and
electronic equipment and its implementation in accordance with national law, electric tools that have
reached the end of their life must be collected separately and returned to an environmentally compatible
recycling facility.