Mirion Technologies DMC 3000, User Manual

Page: 14 / 52

-14-
151153EN-G
DMC 3000 User's Guide
3.1 Fast Entry Mode
The DMC 3000 can be started up using a simplified and quick procedure.
Fast entry
must be enabled using DMC User software.
„
When
fast entry
is enabled, the message "
ENtER
" (1) is
displayed. Simply pressing one of the 2 control buttons immediately
switches the DMC 3000 dosimeter into Run mode.
„
The message "
IN
" (2) is briefly displayed (*) .
„
The dosimeter switches to measurement mode (3).
„
The display starts to indicate the dose measurement.
Note:
There are two configurations of fast entry (Fast entry and permanent fast entry)
- In fast entry, as soon as the dosimeter switches back to Pause mode, the fast entry
mode is disabled. To return to fast entry mode set parameters again.
- If the permanent fast entry mode is set, the DMC 3000 will revert to fast entry mode when back
in Pause.
(*) Depending on the versions, the message "IN" may not be displayed.
(1)
(2)
(3)
Note:
DOSIMASS-DM does not have the
ability to modify the DMC 3000's
parameters.
3.2 Operating Modes
DMC 3000 dosimeter can be used in the following modes:
-
Autonomous mode
:
Dosimeter's two buttons can be used to set alarm set points and switch
back and forth between
Pause
and
Run
.
-
Satellite mode
:
DMC User
software must be used to configure the DMC 3000.
Readers must be used to turn ON (Run) and OFF (Pause) the DMC 3000.
3- Oper
ation