36
Installing the NC-210/NC-211 Beacon
2. Close jumper JW1.
Figure 27 JW1 on NC-211
3. Attach the back cover and secure it with the 4 screws.
Troubleshooting the NC-211 Battery
If the blue (rightmost) LED blinks, it means that the battery has stopped charging.
•
Unplug the beacon, wait for 1 minute, and then plug the beacon back into the wall.
•
If the blue LED continues to blink, then contact Mircom customer service.
4.3.4 Audible Low Battery Indication
The NC-211 beeps when there is no AC power and the battery is low. When AC power is
restored, the battery starts charging and the beeping stops.
Attention: The beacon’s antenna is attached to the front cover. Be careful not to
damage the antenna wire when you open and close the enclosure.
Close
JW1
!
Summary of Contents for MiCare NC-103
Page 2: ......