Miranda ADX-102i, Manual To Installation And Operation, Page: 21 / 25

15
3.8 Audio and Time Code Delay
(
DLY
)
It is possible to add an audio delay of up to 6 fields, by steps of one field. The time
code may be set to track the audio when a delay is applied. To add audio delay,
follow these steps:
7. Press SELECT to enter the menu. OUT is displayed.
8. Press the (+) push-button until DLY is displayed.
9. Press SELECT to enable the delay menu. AES is displayed.
10. Press SELECT to enable the AES delay menu. The current audio delay
setting is displayed.
11. Press (+) or (-) to set the desired delay or NONE. For a quicker response,
keep the push-button depressed. Press SELECT to store the new delay and
return to AES.
12. Press (+) once to select LTC.
13. Press SELECT to enable the LTC delay menu. The current LTC delay setting
is displayed.
14. Press (+) or (-) to set the LTC timing to track the audio (TRAK) or NONE.
Press SELECT to store the new setting and return to LTC.
15. To return to normal mode, press ESC twice.
3.9 Channel Status Information
(
STAT -> AES1 to AES2/4/8)
This menu is used to display channel status information of the AES output signals.
Different information can be displayed for each AES signal.
Note: these settings follow the information disembedded from the 4:2:2 signal.
BITS
: Indicates the encoded audio sample word length for the AES channel:
16, 20 or 24 bits, or OTHR for other sample word length (17, 18, 19, …
bits)
MODE
: Indicates if the channel is non-stereo (1 CH), stereo (ST), has distinct
left and right audio signals (2 CH) or has a primary and secondary
audio signal (P/S). When mode is not indicated N.I. is displayed.
EMPH
: Indicate the type of emphasis used to encode the audio signal: 50-15
us (5015), J17 or none (NONE) if no emphasis is inserted. When
emphasis is not indicated N.I. is displayed.
USE
: Indicates the use of channel status block: professional (PRO) or
consumer (CONS).
Follow these steps to add these information:
1. Press SELECT to enter the menu. OUT is displayed.
2. Press the (+) push-button until STAT is displayed.
3. Press select to enable the STAT selection menu. AES1 is displayed.
4. Press the (+) or (-) push-button until the desired AES audio output is
displayed.
5. Press SELECT to access the channel status information settings. BITS is
displayed.
6. Press SELECT to enable the BITS menu. The current audio sample word
length for the selected audio signal pair is displayed.
7. Press ESC return to BITS.
8. Press the (+) push-button once to display the next channel status
information.