10
maInTenance
cleaning
Many household cleaners contain abrasives and chemical substances, and should
not be used for cleaning plated or plastic fittings. These finishes should be cleaned
with a mild washing up detergent or soap solution, and then wiped dry using a soft
cloth.
1.
Use your thumb or a soft cloth to wipe
any limescale from the soft rubber
nozzles and the front face of the
spray plate assembly
Important!
the
sprayplate must be regularly cleaned
to make sure that the showerhead
does not become blocked.
FaulT dIaGnoSIS
the trouble shooting information tabled below gives details on what you can do as
a user, should you encounter difficulties with the shower fittings whilst operating
the shower. Before replacing any parts make sure that the underlying cause of the
malfunction has been resolved.
malfunction
cause
remedy
No flow or low flow
Spray plate blocked.
hose blocked or twisted.
Problem with shower control.
refer to section
'maintenance, cleaning'
.
clear blockage or release
twist in hose or renew hose.
refer to the shower control
Installation and User Guide.
Drip from spray
plate assembly in
Showerhead.
a small amount of water may
be retained in the shower
fitting after the shower control
has been turned off. this may
drain over a few minutes.
this is quite normal. changing
the angle of the showerhead
may vary the draining time.
Shower temperature
changes when spray
action is adjusted.
adjusting the spray action
changes the flow of water.
this may affect some shower
c o n t r o l s a n d p l u m b i n g
installations.
to minimise the effect make
sure that the spray plate
is clean. refer to section:
'
maintenance, cleaning'
.
If the malfunction persists
refer to the shower control
Installation and User Guide.
