10
6.
Slide the clamp bracket, hose retaining ring,
compression nut and olive onto the rigid riser
rail and locate into the diverter outlet.
7.
Make sure that the securing bracket cover is
fitted onto the rigid riser arm, then fix the pipe
to the securing bracket with the pin. Screw
the securing bracket cover over the securing
bracket.
8.
Tighten the compression nut using a suitable
spanner.
Note!
Hold the diverter in position whilst
tightening the compression nut.
9.
Fit the 12 L/Min flow regulator into the hose
then screw the hose onto the outlet of the
diverter, making sure that the hose seal is
fitted.
10.
Pass the flexible hose through the hose
retaining ring and screw the remaining end of
the hose onto the showerhead making sure
that the hose seal is fitted.
11.
Place the showerhead in the clamp bracket.
18.
Make sure that the hose washer is fitted and
screw the fixed showerhead onto the rigid riser
arm.
12.
Turn on the hot and cold water supplies and
check for leaks.
13.
Before using the shower, refer to section:
‘Commissioning’
.
Pin
Clamp Bracket
Compression Nut
Olive
Hose Seal
Hose
Securing Bracket
Securing Bracket
Cover
Hose Retaining
Ring
12 L/Min Flow
Regulator
