Minuteman Smart Up MSU 1000, User Manual

Page: 8 / 24

REAR PANEL
The Accessory Slot is used for SNMP UPS monitoring. Available from Minuteman.
The DB9 connector is used for UPS monitoring and control through a computer’s serial port
(see Section 3).
The Option Slots are for adding RJ-45/RJ-11 surge protection cards. Available from Min-
uteman.
The Site Wiring Fault LED illuminates when the UPS detects an improperly wired AC power
outlet (see Section 3).
The Output Power receptacles are NEMA 5-15R type for 120V units and IEC 320 for 230V
units.
The Input Power receptacle is a IEC 320.
The Input Circuit Breaker will trip in the event the load exceeds the UPS’s power rating.
INSTALLATION PLACEMENT
Please observe the following items:
n
Install the UPS in a temperature-controlled, indoor environment that is free of conduc-
tive contaminants. Select a location which will provide good air circulation for the UPS
at all times. Avoid locations near heating devices, water or excessive humidity, or
where the UPS is exposed to direct sunlight.
n
Plug the UPS into a two pole, three wire, grounded receptacle only. Do not use exten-
sion cords or adapter plugs.
DB9 CONNECTOR
Minuteman Power Management software and interface cable kits are used with this port
(software and cables are optional and available from Minuteman). Use only Minuteman or
Minuteman approved interface cables with these UPS’s. Connect the interface cable to the
DB9 connector on the rear of the UPS. Secure the connector to the UPS via the screws on
the connector housing. Connect the other end of the cable to the device that will be monitor-
ing/controlling the UPS.
NOTE:
CONNECTING TO THE DB9 IS OPTIONAL. THE UPS WORKS PROPERLY
WITHOUT A CONNECTION.
6