Parts and Instruction Manual -
Mirage 27” Propane Burnisher
Page 4
Machine Troubleshooting
When troubles occur, be sure to check simple causes which at first may seem too obvious to be considered. For
example, a starting problem could be caused by fuel starvation due to an empty propane cylinder or an unopened
service valve.
1. EXCESSIVE VIBRATION: Look for the following possibilities:
(1) Pad is off center. Remove and reinstall.
(2) Pad Driver is cracked. (Possibly from striking a curb or bolt in the floor) Replace at once with a new part.
(3) Bearings in Front End Assembly are worn. Tilt machine back on its rear bumper. Grip Pad Driver and move up,
down and from side to side to check for slack in the bearings. If slack exists, Front End Assembly should be
replaced.
2. EXCESSIVE NOISE FROM UNDER MACHINE: If this problem has developed after use of a new machine, the first
place to check is the tensioner. As a new belt wears in, it naturally stretches and the tensioner could begin to
rattle. Tilt the machine back on its rear bumper and reset by taking up the slack in the belt and tighten the
tensioner.
For additional troubleshooting, refer to the Troubleshooting Guide on page 15.
Summary of Contents for Mirage 27"
