Minuteman ERS1500RTNC, User Manual

Page: 7 / 15

11 10
4. Use the template to mark the screw hole position on the wall. CAUTION,
you should always were protective gear for your hands and eyes when
operating power tools.
5. Attach the four retaining screws to the wall and make sure that all of the
retaining screws are screwed into structural material. Then clean the area
of any loose material. Do not tighten the retaining screws all the way, leave
approximately 3/8" of the retaining screws sticking out.
6. Position the UPS, so that the mounting bracket keyed holes line up with the
four retaining screws. Slide the UPS down until its resting securely on the
four retaining screws.
7. Tighten the four retaining screws to secure the UPS to the wall.
8. The Wallmount Configuration is complete. See Connecting your Equipment.
2. The LED face plate can be rotated to read in the upright position. Remove
the front panel from the UPS. On the backside of the front panel, push the
LED face plate outwards the face plate will pop out. Position the LED face
plate so that it reads in the upright position. Reinstall the front panel on
the UPS.
3. The two rackmount brackets are used for the two tower brackets. Remove
the retaining screws and attached the tower brackets as shown. The tower
brackets go on both sides of the UPS. Make sure that the UPS is stable.
4. The Tower Configuration is complete. See Connecting your Equipment.
WALLMOUNT CONFIGURATION
The wallmount configuration allows the user to mount the UPS on the wall.
There is a wallmount bracket kit available for the UPS. The kit includes two wall
mounting brackets, ten retaining screws, and the wallmount template.
WARN-
ING: Use two or more people when installing the UPS. Use CAUTION, the
UPS is extremely heavy. The UPS's side panels have mounting bracket screw
holes for attaching the wall mounting brackets.
1. Once the location and position of the UPS has been determined, lay the
UPS down flat.
WARNING: The UPS must be installed in the proper upright position. If the
UPS is not installed in the proper upright position the Batteries will be dam-
aged. Once the UPS is placed on the wall, looking at the front panel the
YELLOW Battery disconnected label on the top cover of the UPS MUST be on
your left hand side.
2. Align the mounting brackets with the mounting bracket screw holes and
attach with the six retaining screws.
3. The LED face plate can be rotated to read in the upright position. Remove
the front panel from the UPS. On the backside of the front panel, push the
LED face plate outwards the face plate will pop out. Position the LED face
plate so that it reads in the upright position. Reinstall the front panel on
the UPS.
CONNECTING YOUR EQUIPMENT
Plug the mission critical equipment into the Battery Backup & Surge output
receptacles on the rear panel of the UPS. Plug the noncritical equipment into
the Surge Only output receptacles on the rear panel of the UPS. Ensure that
the connected equipment does not exceed the maximum output rating of the
UPS (refer to the information label on the UPS or the electrical specifications in
this manual). DO NOT PLUG EXTENSION CORDS, ADAPTER PLUGS, SURGE
STRIPS OR POWER STRIPS INTO THE OUTPUT RECEPTACLES OF THE
UPS.
NOTE: Risk of damaging the UPS and/or connected equipment.
CAUTION! DO NOT connect a laser printer to the output of the UPS.