Minuteman ERS1500RTNC, User Manual

Page: 3 / 15

3 2
WARNING:
Risk of Electrical Shock. Hazardous live parts inside these
power supplies are energized from the battery even when the AC input is
disconnected.
CAUTION!
To de-energize the outputs of the UPS:
1. If the UPS is on press and release the On/Off/Test Button.
2. Disconnect the UPS from the AC wall outlet.
3. To de-energize the UPS completely, disconnect the battery.
CAUTION!
To reduce the risk of electrical shock in conditions where the
load equipment grounding cannot be verified, disconnect the UPS from the
AC wall outlet before installing a computer interface cable. Reconnect the
power cord only after all signaling connections are made.
CAUTION!
Connect the UPS to a two pole, three wire grounding AC wall
outlet. The receptacle must be connected to the appropriate branch protec-
tion (circuit breaker or fuse). Connection to any other type of receptacle may
result in a shock hazard and violate local electrical codes. Do not use exten-
sion cords, adapter plugs, or surge strips.
CAUTION!
To reduce the risk of electrical shock with the installation of this
UPS equipment and the connected equipment, the user must ensure that the
combined sum of the AC leakage current does not exceed 3.5mA.
WARNING:
This Uninterruptible Power Supply contains potentially hazard-
ous voltages. Do not attempt to disassemble the UPS beyond the battery
replacement procedure. This UPS contains no user serviceable parts. Re-
pairs and Battery replacement must be performed by
QUALIFIED SERVICE
PERSONNEL ONLY.
CAUTION!
To reduce the risk of fire, connect only to a circuit provided with
20 amperes maximum branch circuit over-current protection in accordance
with the National Electric Code, ANSI/NFPA 70.
IMPORTANT SAFETY INSTRUCTIONS
CONSIGNES DE SÉCURITÉ IMPORTANTES
SAVE THESE INSTRUCTIONS !
SAUVEGARDEZ CES CONSIGNES!
Thank you for purchasing this power protection product. It has been designed
and manufactured to provide many years of trouble free service.
Please read this manual before installing your UPS, model ERS1500RTNC as
it provides important information that should be followed during installation and
maintenance of the UPS and batteries allowing you to correctly set up your
system for the maximum safety and performance.
Veuillez lire ce manuel avant l'installation de l'onduleur modèle ERS1500RTNC.
Il contient de l'information importante qui doit être respectée au cours de
l'installation et de l'entretien de l'onduleur et des batteries. Cette information
vous permettra de correctement installer le système pour atteindre son
rendement maximum en toute sécurité.
Included is information on customer support and factory service if it is re-
quired. If you experience a problem with the UPS please refer to the Trouble-
shooting guide in this manual to correct the problem or collect enough infor-
mation so that the Technical Support Department can rapidly assist you.
CAUTION!
DO NOT USE THE MOUNTING BRACKETS TO LIFT THE
UPS. The mounting brackets are ONLY for securing the UPS to the rack.
CAUTION! This UPS is intended to be installed in a temperature/humidity
controlled environment that is free of conductive contaminants.
ATTENTION! Cet onduleur est conçu pour installation dans un milieu à
température et humidité contrôlées, libre de contaminants conducteurs.
This UPS series is not intended for use in a computer room as defined in the
Standard for the Protection of Electronic Computer/Data Processing Equip-
ment ANSI/NFPA 75.
CAUTION!
The Maximum ambient operating temperature for this UPS se-
ries is 50°C (“-15 ~ +50°C” for Ambient Operation).
NOTICE! The output of this device is not sinusoidal. It has a total harmonic
distortion and maximum single harmonic as below:
Total harmonic 42.8%
Single harmonic 26.6%