background image

MED230CLF

Congratulations on your new Minus40 Refrigerator!

This premium product incorporates the latest innovations in 
refrigeration technology with a highly durable design. Properly 
maintained, the unit(s) will provide many years of reliable service.

MINUS

40

MINUS40 (PTY) Ltd Head Office: 8 Manhattan Street | Airport Industria Ext 2 | Western Cape 

Tel: +27 (0) 21 386 2290 | E-mail: [email protected]

MINUS40 MED230CLF Instruction Manual

Medical Freezer

SAFETY INSTRUCTION

• 

Always disconnect the unit from the mains supply before 
attempting to do maintenance or before removing the bottom 
grille.

• 

In case of unit failure, disconnect it from the power supply and 
contact your service technician or supplier for advice.

• 

If the supply cord is damaged it must be replaced by the 
manufacturer or its service agent or a similarly qualified person 
to avoid a hazard.

CLEANING INSTRUCTIONS

Interior and Exterior Cleaning
• 

Please ensure that the unit has been disconnected from the 
electricity supply.

• 

The unit should be cleaned periodically with a non-abrasive 
cleaner and soft cloth.

• 

Do not use any detergents or abrasive

• 

A damp cloth may be used provided that all surfaces are polished 
dry afterwards.

In the event of the unit not being used for extended periods;
• 

Disconnect from the power supply.

• 

Remove all the medicines & vaccines to another fridge or suitable 
storage.

• 

Thoroughly clean the unit inside and out.

• 

Leave the door(s) slightly open so that air can circulate freely.

• 

Switch the unit back on & wait until temperature has stabalized 
before loading medicine / vaccines

INSTALLATION GUIDE

Follow these easy steps to Install your new Minus40 unit.
• 

Remove all wrapping and packing material.

• 

Be careful not to damage any of the delicate wiring or pipe-work 
in the compressor compartment.

• 

Position the unit out of direct sunlight and away from any other 
sources of heat.

• 

The maximum ambient temperature in which the unit will function 
is 32°C.

• 

The unit may not be built into a furnishing fixture, or have its back 
to the wall.

• 

The unit “breaths” through the grill, and if blocked, the unit will not 
operate properly, damaging the compressor.

• 

Ensure the unit is perfectly level for the door(s) to function 
properly.

• 

Supplied with Voltage Protector

MAINTENANCE INSTRUCTIONS

Repairs:
• 

Before carrying out any maintenance or repair work, please 
ensure that the unit has been disconnected from the mains 
supply.

• 

Any service performed on these refrigerators within the 
1-year warranty period MUST be cleared and reported to the 
manufacturer. Failure to do this will void the standard warranty.

Please read the following instructions carefully as it contains 
important information concerning the safety, installation, operation and 
maintenance of your Refrigerator.

POWER SUPPLY

DO NOT CONNECT THE UNIT TO THE MAINS SUPPLY UNTIL YOU 
HAVE READ THE FOLLOWING INFORMATION.
• 

A qualified person by all local standards and regulations should 
carry out any electrical alterations to the unit.

• 

The  power  supply  should  be  per  the  electrical  specifications 
listed on the rating plate. The rating plate can be located inside 
the unit on the top right-hand side.

• 

Always ensure that the electrical connection is suitably earthed.

• 

An inadequate electrical installation can result in voltage 
reduction at the compressor or cause damage to the motor.

• 

If in doubt about any of the electrical matters mentioned above, a 
suitably qualified electrician should be consulted.

• 

When all of the electrical requirements have been satisfied, the 
unit may be plugged into the mains socket.

VOLTAGE PROTECTOR 

The Refrigerator must always be connected to a voltage protector 
supplied. If neglected the warranty will be void.

Summary of Contents for MED230CLF

Page 1: ...ng or pipe work in the compressor compartment Position the unit out of direct sunlight and away from any other sources of heat The maximum ambient temperature in which the unit will function is 32 C The unit may not be built into a furnishing fixture or have its back to the wall The unit breaths through the grill and if blocked the unit will not operate properly damaging the compressor Ensure the ...

Page 2: ...g it in If you hear it running a problem is causing the compressor to overheat Check if the evaporator fan is running Listen if the compressor ever runs If not the compressor might be faulty Unit is not cold enough Check the temperature setting Assure that there is enough room for airflow in the fridge Check for airflow restrictions in front and at the back of the grille Clean the condenser coils ...

Page 3: ...a car radiator Soft Brush Take a soft brush and clean the fins CAUTION The condensor is very delicate Do not to bend the fins Never poke anything through the fins Never use water Never use a hard brush Vaccuum If possible use a vaccuum to clean away the debris Check the rest of the compartment for any foreign objects and remove Remove Tools Ensure that all tools have been removed Voltage Protector...

Page 4: ...ease indicate the DAYS that the condenser is cleaned on the chart Date cleaned marked with an X 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 Jan Feb Mar Apr May Jun Jul Aug Sep Oct Nov Dec Clean the condenser with a soft brush Check the condenser monthly If there is dirt of fluff on the condenser clean as above Mark the chart above with a cross on the DAYS th...

Reviews: