18
Once the freezer is running, the inside temperature will start to cool down within a couple of minutes.
Ensure that the freezer has reached the desired temperature (this will take between 2 to 3 hours) by
checking the electronic control display readout before loading product.
It is strongly recommended to
run the freezer empty for 24 hours before loading any products.
NOTE:
If the freezer is running and the power supply is interrupted, the freezer will not restart
Immediately. There is a 6 minute delay for compressor protection.
OPERATING INSTRUCTIONS
WARNING
Check with your power company if you are not certain of your power supply.
Before connecting to power supply the freezer should be upright and idle for at least 1 hour.
3
ILLUSTRATION: 13-USGF, 19-USGF, 22-USGF
SHELF AND BASKET, INSTALLATION AND ADJUSTMENT
The freezer is supplied with shelves and molded or metallic clips. The freezer has slotted pilasters to po-
sition the shelves according to the customer’s needs.
Metallic Clip
Shelf
Shelf
Molded Clip
The clips can be removed at any time if a new position is chosen for the shelf or basket. To remove, grab
the clip with your thumb and index finger, then push up the bottom surface until the clip is free. Once
the clips are in place, put the shelf on top. Once the shelves are securely in place, baskets (if equipped)
may be positioned on the shelves.
Once the unit has been installed and the power supply has been connected, press
the power switch to the “ON” position using a pen or pencil.
The compressor will start to run after 6 minutes. This can be confirmed by lis-
tening for a slight humming or a slight vibration.
Summary of Contents for 09-USGF
Page 2: ......
