9
12
EXTERIOR CLEANING
Use only mild non-abrasive liquid cleaner, water and a soft cloth for the painted surfaces and
a stainless steel polish and cleaner for the stainless steel surfaces if desired.
CLEANING GLASS DOOR EXTERIOR
Due to the special coating on the glass, use only a mild, non-abrasive liquid cleaner, water,
and a soft cloth. The same applies to the plastic door frame.
ANTI FOG GLASS DOOR INTERIOR
The anti-fog glass door has a protective film on the inner side. After the unit has been
installed, peel and remove the protective film covering the inner glass surface.
The Anti-Fog coating is a scratch resistant, permanent coating applied on the inner surface
of the door glass. It prevents fogging and icing of cold glass surface after door opening and
closing.
Cleaning can be performed using common household glass cleaners (Sidolin
®
, Windex
®
,
Mr. Muscle
®
) and a tissue or paper towel. However, on very cold surfaces these cleaners may
freeze. In these cases a mixture with 30% pure alcohol and water may be used.
At temperatures above 0°C, warm hand temperature water with a mild detergent can be
applied.
Do not use
abrasive cleaners or materials like Ajax
®
, Scotch Brite
®
or Steel Wool.
Do not
contaminate the door with silicone.
Do not use
tape, glue, stickers, attachments, magic markers or similar products on the
coating.
Do not use
razor blades or any other mechanical device to remove foreign residues or
objects directly from the coating.
Do not use
cleaners or materials that hinder the anti-fog performance by leaving residue or
damaging the surface. Examples of these cleaners include: ArmorAll
®
, Tilex
®
, Bleach,
Windex
®
No-Drip, Windex
®
Wipes, Pledge
®
, or any product containing silicone oils or waxes.
Recommended cleaners
include: Greased Lightning
®
, Formula 409
®
Grease & Grime
®
,
Fantastik
®
, Windex
®
Vinegar, Windex
®
Original, MicroClean Professional APC
®
(formerly
Now
®
all purpose cleaner), Mean Green
®
, or Mr. Clean
®
(degreasing cleaners).
Recommended cleaning
is with a soft dry or slightly damp towel, or with one of the
degreasing cleaners listed above.
CABINET CLEANING (CONT’D)
Remove silicone corner beads.
Pry the screwdriver between
plastic cover and cabinet frame.
Pry from one end to the other.
Pry the screwdriver between
plastic lens cover and cabinet
frame.
Locate the wire for the LED
strip in the compressor com-
partment and disconnect from
connectors.
Carefully remove the plastic
lens cover from cabinet frame.
Install the new LED strip into
the plastic cover.
Attach wires, observing color
coding. Press lens cover back
to cabinet frame.
INTERIOR LED STRIP REPLACEMENT
Plug the unit in and make sure
the light switch on the
bottom grill is in the ‘ON’
position.
WARNING
Make sure the unit is disconnected from the power supply before any service. Press the
power switch to the “Off” position then unplug the power cord from electrical receptacle.
All service work must be conducted by a certified technician only.
Slide faulty LED strip from
plastic cover.
Snap plastic cover back to cab-
inet frame. Apply silicone at
plastic cover corners.
Summary of Contents for 09-USGF
Page 2: ......
