6
5
1. Comp - Indicates compressor status:
Light off - Compressor off
Light on - Compressor on
Light flashing - Start-up delay in progress
2. Def - Indicates defrost status:
Light on - Defrost in progress
Light flashing - Refrigerator in dripping mode
3. ( - ) - Indicates low temperature alarm status:
Light on - Low refrigerator temperature alarm in progress
Light flashing - Low temperature alarm memorized
4. OK - Indicates that no alarms are in progress.
This is the normal mode for the refrigerator.
5. ( + ) - Indicates high temperature alarm status:
Light on - High refrigerator temperature alarm in progress
Light flashing - High temperatures alarm memorized.
6. Fan - Indicates fan status:
Light on - Cabinet fan ON
Light off - Cabinet fan OFF
Light flashing - Start-up delay in progress after defrost, door open,
delay in progress due to high refrigerator temperature.
At the bottom of the controller display are the following LED indicators:
CONTROLLER ALARMS AND SIGNALS CONT...
CONTROLLER SYMBOLS AND FUNCTIONS
1
2
3 4 5
6
Message
Cause
Action
StArt dELAy
Start up delay in progress
• Wait for 6 minutes
Hi °F or Hi °C
Maximum temperature alarm
• Check door
• See Troubleshooting (page 12)
Lo °F or Lo °C
Minimum temperature alarm
• Adjust set temperature
door oPEn
Door open
• Close door
GENERAL
The refrigerator should be cleaned at regular intervals to meet a good standard of hygiene
and to keep the refrigerator attractive as an effective point of purchase display.
INTERIOR CLEANING
Use only mild non-abrasive liquid cleaner, water and a soft cloth for the entire refrigerator
interior. Make sure to wipe off all residue.
EXTERIOR CLEANING
Use only mild non-abrasive liquid cleaner, water and a soft cloth for the painted surfaces and
a stainless steel polish and cleaner for the stainless steel surfaces if desired.
CLEANING GLASS DOOR
Due to the special coating on the glass, use only a mild, non-abrasive liquid cleaner, water,
and a soft cloth. Same applies to the plastic door frame.
CLEANING
WARNING
To reduce the risk of fire, electrical shock or personal injury, disconnect the refrigerator from the
power source before cleaning. Press the refrigerator switch to the “Off” position, then unplug the
power cord from the receptacle. Keep liquids away from electrical and electronic components.
To clean the exterior whether it has the original finish or a decal package, use only a mild non-abrasive
liquid cleaner, water and a soft cloth. For stainless steel parts, a commercial stainless steel polish and
cleaner can be used. Always apply the cleaner to the soft cloth and then clean the refrigerator. Never
apply the cleaner directly to the refrigerator. Excess liquid applied to the surface may seep into the elec-
tronic control and switches which can cause an electrical hazard or a malfunction.
DO NOT USE
abrasive or caustic cleaners, scouring pads, solvents or flammable liquids.
CAUTION
Do not apply hot water on cold glass components. Allow glass to warm sufficiently to prevent
shattering.
CAUTION
Do not use ammonia or bleach based cleaners or abrasive type cleaners.
Do not use abrasive cleaning pads.
