3.
Fully open both legs and place the V130M on a
flat and level floor.
At this moment, make sure all 4 foot are in
contact with the floor at once so the trainer sits
on the floor evenly. (see Fig. B)
How To Setup Your V130M Trainer
2.
Remove the bolt and nut which are pre-installed to the bracket on the Main Frame. (see Fig. A-1)
Put the Metal Plate Nut into the hole on the bracket of the V130M frame, then screw the Roller Pressure
Adjust Knob (MF-3) with an acorn spring and a flat washer to the nut. (see Fig. A-2)
Install the Mag resistance unit to the forwad hole on the bracket of the frame. (see Fig. A-3)
- Page 4 -
1.
Replace your rear wheel quick release skewer to the supplied one.
Minoura guarantees the stability only when using the supplied skewer due to the coupling inner shape.
!
If your bike is not equipped with quick release skewer and it's a hub nut type, you
should remove the black plastic Grommet (Skewer Nut Protector) (F-9) from the
right side Coupling (F-1).
Minoura doesn't guarantee the stability if you don't remove the Grommet.
You don't need the supplied quick release skewer if your wheel is a hub nut type.
It's not possible to convert your wheel from the hub nut type to the quick release
skewer type unless you replace the entire wheel.
!
Required Tools:
1 x 10mm Spanner
1 x M4 Hex Wrench
!
Make sure the acorn shaped spring
direction must be as shown in Fig. A-2.
Adjustment is impossible otherwise.
(Fig. A-2)
(Fig. B)
!
Adjust the fixing bolt tightening as the
Mag unit moves down slowly with its
own weight when you turn the knob
bolt counter-clockwise.
Do not overtighten the fixing bolt or
the unit won't move properly.
Too loose setting may pinch your
finger when you release the unit.
Use caution.
!
Do not bend the remote cable sharply.
(Fig. A-3)
Metal Plate Nut
Knob Bolt
Remove both bolt and nut
(Fig. A-1)
Flat Washer
Acorn Spring