- 6 -
The Mag unit has 7 different levels of load force, replicating actual riding resistance.
The load settings range from high (H) to low (L) can be adjusted via the side lever on the Magturbo unit or the
lever on the remote shifter lever. You may also adjust the load force by shifting up or down among your gears,
depending on the level desired.
We recommend that you start with a medium to low load force and gradually work up, increasing force as your
muscles warm up.
Increasing Load Force
Decreasing Load Force
To decrease the load force, move the side lever on Mag unit toward the (L)
symbol. (see Fig. M)
Be sure the lowest selection is not zero load, there still be a small level of force.
If your Mag unit is a remote control type, turn the lever on your re,pte shifter
toward the (L) symbol. (see Fig. K)
To increase the load force, move the side lever on the Mag unit toward the (H)
symbol. (see Fig. L)
If your Mag unit is a remote control type, turn the lever on your remote shifter
toward the (H) symbol. (see Fig. K)
(Fig. M)
HOW TO INSTALL THE REMOTE SHIFTER
USING THE MAG RESISTANCE UNIT
(Fig. I)
(Fig. J)
1
2
1) Wind the band around the handlebar and hook the metal ring to the gutter on the remote shifter base,
then 2) flip up the lever to lock (see Fig. I). If it is loosened, adjust the band tighter.
The soft fabric band is pre-adjusted to fit normal 22mm diameter handlebar.
If you need to mount onto an oversized or specially shaped handlebar or stem, adjust the band (see Fig. J).
At this moment, you should slide the guide pin downward to loosen the band for easier work.
(Fig. K)
1
2
1
2
3
The R model has a convenient remote shifter lever. You can install it on the handlebar or stem, then you can
control the resistance level without getting off the bike.
(R model ONLY)
Decrease
Increase
(Fig. L)
