- 8 -
FOR MORE INFORMATION
Proudly made to exacting standards in Japan
Copyright © 2003-2004 Minoura Co., Ltd., All Rights Reserved.
MINOURA JAPAN HEAD OFFICE
MINOURA JAPAN HEAD OFFICE
MINOURA JAPAN HEAD OFFICE
MINOURA JAPAN HEAD OFFICE
MINOURA JAPAN HEAD OFFICE
1197-1 Godo, Anpachi, Gifu 503-2305 JAPAN
Fax +81-584-27-7505 / E-mail: [email protected]
http://www.minoura.jp
MINOURA NORTH AMERICAN WARRANTY CENTER (for U.S. Residents only)
MINOURA NORTH AMERICAN WARRANTY CENTER (for U.S. Residents only)
MINOURA NORTH AMERICAN WARRANTY CENTER (for U.S. Residents only)
MINOURA NORTH AMERICAN WARRANTY CENTER (for U.S. Residents only)
MINOURA NORTH AMERICAN WARRANTY CENTER (for U.S. Residents only)
In Canada, have your local shop contact Norco Products for warranty and parts service.
In Canada, have your local shop contact Norco Products for warranty and parts service.
In Canada, have your local shop contact Norco Products for warranty and parts service.
In Canada, have your local shop contact Norco Products for warranty and parts service.
In Canada, have your local shop contact Norco Products for warranty and parts service.
1996 East Avenue, Hayward, CA 94541-5454 U.S.A.
Fax 1-510-538-5899 / E-mail : [email protected]
If you cannot shift to either the lowest (L) or the highest (H) position, it is possible
that the inner wire of the remote shifter cable is too long and the wire tension is
loose. If so, please adjust the tension with the following steps.
Wire Tension
Adjusting Screw
Nut
Plastic Cap
Cable
(Fig. R)
TROUBLE SHOOTING YOUR REMOTE SHIFTER UNIT
1
2
3
Set the remote shifter lever at “H” position. Remove the remote shifter
device from the handlebar and straighten the cable.
Remove the plastic cap located on the bottom of the cable. (see Fig. R)
Hold the adjusting screw with your right hand and push it towards the
direction of the outer cable, then adjust the nut with your left hand to make
the wire tension properly.
If you experience that the remote lever will move toward “H” unexpectedly automarically when you pedal hard,
try to tighten the adjusting screw 1/4 rotation. It is located under the remote lever holder.
