Do not install the Pivot
Pin from the top.
You will not be able to
use the hex wrench.
!
When installing the clamp band to
the smaller diameter Center Pillar,
you must put the gray Plastic Shim
between the clamp band and the
pillar as a spacer.
Make sure the dual ribs are located
on the single arm side. (see Fig. V)
2
Wrap the clamp arm around the pillar. (Fig. U)
The clamp has single arm side and twin arm side.
This instruction tells as you set the single arm on the
right hand side, but the clamp is universal with no
specific direction.
3
Put the Pivot Pin through all 3 holes on the clamp
band from bottom side, and screw the Pivot-Pin
Fixing Bolt with a flat washer temporarily.
(see Fig. W)
!
Do not tighten the Pivot Pin
Fixing Bolt firmly yet.
If you tighten too much, the
next step will become difficult.
4
Turn the Pivot Pin to align the thread hole to the
side hole on the Clamp Band.
Screw the Clamping Bolt into the Pivot Pin.
(see Fig. X)
Tighten the Clamping Bolt first, then tighten the
Pivot Pin Fixing Bolt later firmly (
8 N.m
).
5
If you need to adjust the clamp position along
the same pillar, simply loosen (do not remove)
the Pivot Pin Fixing Bolt and the Clamping Bolt
slightly.
6
8 N.m
Tighten
How To Reinstall The Clamp
You may need to remove and change the installation position of the bike cradle from the fatter Upper Pillar to the narrower
Center Pillar depending on the bike size or the bike layout. To do so, follow the steps below.
If you just change the installation position among the same pillar, just loosen the clamp, no need to remove.
1
You can change the clamp position while the
cradle is still on attached to the clamp.
Loosen and remove the Pivot Pin Fixing Bolt, the
Clamping Bolt, and the Pivot Pin.
Now you can open the clamp arms to remove it
from the pillar.
Required Tool : 5mm Hex Wrench
- 7 -
!
When sliding the clamp on the pillar,
loosen the screws and open the
arms as widely as possible in order
to avoid scratching the pillar.
Do not twist the clamp along the
pillar, but slide it straight up or down
gently.
(Fig. U)
(Fig. V)
(Fig. W)
(Fig. X)
(Bike Cradle is deleted in this section for explanation.)
Upper or Lower
Pillar
(Larger diameter)
Center
Pillar
(Smaller
diameter)
Install Shim
To Adjust On The Same Pillar
Warranty Period
Minoura offers
1-year limited warranty
to this product
from the date of your purchase.
Any natural wear and the problems caused by miuse
or unapproved modification will not be covered by this
program.
For more details, read the enclosed
Minorua Limited
Warranty Policy
card in the kit.
Also please regularly check our Minoura web site for the
latest information.
