- 6 -
Schematics of Bike Cradle
Arm Bar
Cradle Cap
(assembling required)
Base Plate
Clamp Body
(pre-installed on
the pillar)
Pivot Pin
Pivot Pin
Fixing Bolt
Hook Fixing Bolt
with Spring & Flat
Washers
Clamp Connecting Bolt
(Center)
(assembling required)
Clamping Bolt
1
The clamp body has been pre-installed on the pillar. You will install the bike cradle to the clamp.
The hook and the cradle cap are separated. You will install them on the cradle later.
Hook
(assembling
required)
Angle Adjusting
Bolt
(Left & Right)
Pad
!
Be sure to put the rectangle projection evenly and into the hole level. If it is not completely
level, the clamp may be damaged and it will become difficult to screw the Clamp Connecting
Bolt into the thread hold on the Clamp Body.
The clamp body is made of soft light alloy material and this part cannot be repaired. You
must replace it at your own expense if damaged.
!
A thread has a unique physical mechanism that you can screw the bolt in the slightly slanted
angle.
The bolt will stop turning after 2-3 rotations so do not force the bolt any further or you could
cause damage to the stand.
You must confirm first that you can rotate the bolt at least 3 rotations smoothly without using
any tool. After that, you can use tool for tightening more.
2
Screw the M6x20 cap bolt in the parts pack to the Clamp body through the center hole on the Arm Bar. Tighten the bolt
firmly by 5mm hex wrench.
!
After installation of the Cradle Cap, you will tighten or loosen the bolts through the hole on
the cap.
When you need to remove the cradle from the clamp body, you should not keep pushing
the cradle forward. The cap will lift up naturally while loosening the bolt. Otherwise, the bolt
head may push and remove the cradle cap.
Install the rectangle projection part of the Clamp Body into the rectangle hole on the Base Plate. (Fig. T)
3
Install the Hooks to both ends of the Arm Bar.
The hook is position and angle adjustable in order to fit your bike frame size and design as perfectly as possible.
Required Tool: 5mm Hex Wrench
How To Install Bike Cradle
4
Install the Cradle Cap to the Base Plate.
You should attach the cap bottom first, then push the top for better installation. Failure to do so may cause the cap
breakage problem.
(Fig. T)
