background image

- 4 -

3

!

Do not remove the Arm Connecting Screw. 
Just loosen.

Each arm is fully angle 
adjustable in +/- 35 degrees in 
order to fit various types and 
sizes of bike frame (see Fig. G).

!

Do not set both hooks higher than level. 
The hook which holds the main load must 
be located lower than the clamp body.

!

Tighten every bolt firmly before loading the 
bike. If the arm fixing screws have been 
loosened, they may come down due to the 
bike weight and may drop the bike in the 
worst case.

Insert the Pivot-Pin to the clamp from 
bottom hole, and screw the Pivot-Pin 
Fixing Screw with a washer to hold the 
pin (see Fig. D).
You don't have to tighten the bolt 
firmly yet.

4

Rotate the Pivot-Pin to align the thread 
hole on the pin and the side hole on 
the clamp body, then screw the Clamp 
Tightening Screw.
(see Fig. E).
You don't have to tighten the bolt firmly 
yet.

5

After fixing the clamp height 
and angle, tighten the Clamp 
Tightening Screw first (see Fig. F).

(Tightening Torque: 3 N.m)

After that, tighten the Pivot-Pin 
Fixing Screw to secruely hold the 
clamp.

(Fig. D)

(Fig. E)

(Fig. F)

6

(Fig. G)

7

To change the arm angle, insert an M5 hex 
wrench into the center hole on the Cradle Cap 
then loosen the Arm Connecting Screw.
(see Fig. H)

(Fig. H)

8

Loosen the backside screw which holds the arm, 
grab the arm and change the arm angle.
After changing the angle, tighten the screw firmly. 
(see Fig. I)

(Fig. I)

Contact

MINOURA JAPAN

1197-1 Godo, Anpachi, Gifu 503-2305
Phone +81-584-27-3131 / Fax +81-584-27-7505
[email protected] / www.minoura.jp

Made in Japan

If  you need help or have a question, please contact the shop first 

where you originally purchased this product.

If  you cannot get enough service or answer from them, you can 

contact us directly.

Reviews: