49
48
Without diffuser
With diffuser
Strong shadows can be softened by using the diffuser attached to
the flashtube. Always use the diffuser with an arm set at the 90 °
position. If the arm is set at the 60° position and used with a wide
angle lens, the diffuser may be show in the image.
1. Prepare the diffuser for use.
DIFFUSER (TWIN FLASH ONLY)
Slide tab through the slot
near the clip.
Place the four side tabs into each
slot on the side of the diffuser.
• If it is difficult to assemble the diffuser, fold
it and try again.
• The diffuser should assemble easily. Do
not force or pull hard on the diffuser.
• Do not fold the diffuser inside out.
2. While holding the diffuser by its top tab, press it against
the face of the twin flash unit until it clicks and is secure-
ly mounted.
Align the lower edge.
The dimple above the
slot should slide into
the hole in the tab.
Unclip the adapter
from the diffuser.
This side cannot
be detached.
Without diffuser
With diffuser
Assembled
