12 (2786)A
REPAIR GUIDE
Missing Pixel (Defect) Compensation Adjustment (in the LCD section)
The adjustment is an image correct function that can restore the bright spots at long exposure.
Whenever after replacing the CP-1 Compl PWB (#0408), the PW-1 Compl PWB (#0432,0452), the ST-1
Compl PWB (#0406) or the Lens Assy (#3255-0600), be sure to perform the adjustment.
■
Equipment Required
PC (IBM PC/AT Compatible Computer with the F/X Series Adjustment Program is installed)
USB cable USB-500
AC Adapter AC-6
■
Adjustment
1. Turn the mode dial to Auto-recording position.
2. Connect the camera to the computer with the USB cable USB-500, and start Adjustment Program
(DscCalDi.exe).
3. Click the scroll arrow of "Test" in the LCD section of the adjustment screen, and select "CCD Defect"
from the pop-up menu of "Test".
"CCD Defect Detection. Yes or No" appears on the screen.
4. According to the screen, click "Yes".
The camera electronically makes 4-sec. exposure to map out dead pixels. Up to 512 pixels can be
restored at a time. The number of the missing pixels is displayed on the screen. (Fig. 1)
5. Click "OK" on the screen to return to the adjustment screen.
■
Adjustment Error ("Defect NG")
When the "Defect NG" appears during adjustment, take the following actions.
-Turn off the camera for 30 minutes or longer to cool down before re-adjusting.
-If the same error appears after re-adjustment, the CCD may be defective.
-Replace the Lens Barrel Assy (#3255-0600).
Fig. 1
Fig. 1
Fig. 1
Fig. 1
Fig. 1
CCD Results :
Dsc Calibration
DSC
Cal.
OK
Copy
number=512
