Minolta 3D 1500, Manual

Page: 17 / 30

BASIC RECORDING PROCEDURE - CONT’D
- 33 -
BASIC RECORDING PROCEDURE - CONT’D
- 32 -
Make sure that the Flash-ready
lamp on the MetaFlash unit turns
on.
• You can click the shutter even when the
MetaFlash unit is not fully charged. Be sure
to check that the MetaFlash unit has been
fully charged (the Flash-ready lamp is lit)
before taking a picture.
Press the shutter-release button
part way down.
When the green focus lamp
glows, press the shutter-release
button the rest of the way down
to take a picture.
• In a dark situation, the built-in flash emits a
small amount of light as a supplementary
light source to illuminate the subject when
you press the shutter-release button part
way down.
• A Blinking green focus lamp indicates that
the subject is out of focus. See Page 36 of
the Dimâge EX Camera Instruction Manual.
When the Instant Review is on,
the screen shown in the upper
left figure will appear every time
you finish taking a picture.
• To record (save) the image on the CF card,
press the Save soft key (soft key (right)).
• When not recording (saving) the image on
the CF card, press the Delete soft key (soft
key (center)). The confirmation screen
shown in the lower left figure will appear.
Press the Yes soft key (soft key (left)).
• You can disable the Instant Review feature if
you find it cumbersome to select either Save
or Delete every time you take a picture (in
which case the image is recorded on the CF
card immediately when you take a picture).
For instructions, refer to Page 58 of the
Dimâge EX Camera Instruction Manual.
• The LCD monitor is held off while the image
you shot is being recorded. The monitor
turns on again when recording (saving) is
completed.
Any changes you made to the following items will be ignored in the 3D mode:
• Still Picture Settings
• Timelapse Settings
• White Balance Settings
The following functions remain disabled in the 3D mode:
• Bracketing
• Flash Bracketing