minnkotamotors.com | 2
©2015 Johnson Outdoors Marine Electronics, Inc.
Aluminum Support Plate
Proper Alignment
Deck
INSTALLATION
a. Complete installation of the Pontoon Edge Mount
Kit (1810225).
b. Place the Aluminum Support Plate (Item #1) below
the pontoon deck against the closest and opposite
support beam that is parallel to the support plate
already installed with the Standard Talon Pontoon
Adapter Bracket mounting kit as shown.
1
2
3
e. Secure the Aluminum Support Plate to the
pontoon deck with two 2” bolts (Item #5). Place
one Flat Washer (Item #4) on each bolt. Coat the
threads of each bolt with anti-seize. Place the
Aluminum Support Plate beneath the deck and
align the slots with the holes drilled through the
deck.
f. With the washer in place, put one bolt in each of
the holes on top. Each bolt will pass through the
pontoon deck and the Aluminum Support Plate.
Place a Flat Washer (Item #4) and Nylock Nut
(Item #7) at the end of each bolt and secure each
using a ½” wrench and ratchet fitted with a ½”
socket.
c. Once placed, mark the Drilling Locations mid
length in each slot on the bottom of the pontoon
deck. Drill up through the floor using a 3/8” drill bit
on the marked locations.
d. Mark Drilling Locations for the Aluminum Support
Plate on the face of the support beam, mid-length
in each slot for the mounting hardware. Drill
through the face of the beam using a 3/8” drill on
the marked location.
Aluminum
Support Plate
Aluminum Support Plate
Drilling Location
Drilling Location
NOTE:
Be sure to verify adequate
outboard steering clearances, and that
your installation will not interfere with any
previously installed cabling, fuel lines,
or wiring.
Support Beam
Support Beam
Deck
Deck
Support Beam
ITEM(S) NEEDED
ITEM(S) NEEDED
#1 x 1
1b
#5 x 2
#4 x 4
#7 x 2
2d
2c
Drilling Location
Drilling Location
2” Bolt with Flat Washer
Flat Washer with Nylock Nut
