![background image](http://html1.mh-extra.com/html/minn-kota/riptide-terrova/riptide-terrova_owners-manual_1802833023.webp)
minnkotamotors.com | 23
©2022 Johnson Outdoors Marine Electronics, Inc.
STOWING AND DEPLOYING THE MOTOR
STOWING AND DEPLOYING THE MOTOR
To Deploy the Motor
Loosen the Depth Collar, then push firmly down on the Stow
Deploy Lever to release the Lift Assist Collar and slide the motor
forward, out from the Fall Away Ramp. Lower the motor to the
desired depth. Make sure it clicks into a secure, vertical position.
Once at the desired depth, slide the Depth Collar against the Lift
Assist Housing and tighten.
To Stow the Motor
Depress the Stow Deploy Lever. Raise the motor by pulling up on
the Shaft or Control Head. Pull the motor toward the stern until it
rests securely on the Fall Away Ramp and the Fall Away Ramps
capture the Lower Unit. Loosen the Depth Collar and slide it down
and secure it against the top of the Lift Assist Housing to secure
the motor in place and prevent accidental deployment.
CAUTION
For safety reasons, disconnect the motor from the battery/batteries when the motor is not in use or while the battery/batteries are being
charged. If the motor control is left on and the propeller rotation is blocked, severe motor damage can result.
WARNING
The Control Head will create a pinch point if the Depth Collar
Knob is loosened and the Control Head slides to the top of the
Depth Collar. Grasp the Shaft and prevent it from sliding all the
way down to prevent the pinch point.
Practice proper ergonomics when stowing and deploying the
motor to prevent injury.
WARNING
When stowing or deploying the motor, keep fingers clear of all
hinge and pivot points and all moving parts.
WARNING
Moving parts can cut or crush. The Lift Assist Housing can come off of Steering Housing and create a crushing hazard. Keep fingers
clear of all moving parts.
WARNING
If a propeller encounters an obstruction while running, the increased electrical current being generated by the obstruction will signal
the motor to decrease the power to the propeller to prevent damage. If the current overload is detected for more than 20 seconds, the
prop will be disabled to prevent damage to the motor. In this event, the operator can turn the prop back on after being sure that the
obstruction has been cleared.
AutoPilot
The AutoPilot Indicator is located on the Indicator Panel on the Mount. It is illuminated green
when AutoPilot is engaged and it is not
illuminated
when AutoPilot is not engaged for i-Pilot and i-Pilot Link equipped motors.
Stow Deploy Lever
The Stow Deploy Lever is located at the top of the mount. The Stow Deploy Lever functions to unlatch the Fall Away Ramps which rotate to
guide the Lower Unit. The Stow Deploy Lever is actuated by pressing it down.
Summary of Contents for RIPTIDE TERROVA
Page 1: ...RIPTIDE TERROVA BOW MOUNT TROLLING MOTOR Owner s Manual...
Page 61: ...minnkotamotors com 61 2022 Johnson Outdoors Marine Electronics Inc NOTES...
Page 63: ...RIPTIDE TERROVA MOTEUR DE P CHE LA TRA NE MONT SUR L TRAVE Manuel du Propri taire...
Page 123: ...minnkotamotors com 123 2022 Johnson Outdoors Marine Electronics Inc REMARQUES...