MINN KOTA Riotide SP, User Manual

Page: 12 / 26

ADDING /
REMOVING
REMOTES
12
Adding / Removing remotes
• To “learn” the ID number of additional remotes, follow these steps:
1.) Press and hold the LEARN button located on the side of the receiver (receiver will emit a continuous
tone.)
A small blunt object must be used to depress the LEARN button ( pen or screwdriver.)
2.) Press any button on the remote (receiver will beep 4 times confirming that it has “learned” the ID number
of the remote and that the programming is valid and complete.)
• “Re-learning” the ID number of the same remote will not overwrite previously “learned” remotes.
• If the receiver has “learned” the ID number of ten remotes, “learning” an eleventh remote will erase or over write
the first “learned” remote.
• The CoPilot allows the angler to erase all stored remote ID numbers from the receiver. To do so, follow these
steps:
1.) Remove power from the receiver by unplugging the receiver from the motor.
2.) Press and hold the LEARN button and power up the receiver by plugging it back into the motor. Hold the
LEARN button down for 10 seconds. During this time the receiver audio will emit a warble sound, slowly
transition to a constant beep and then shut off.
3.) Release the Learn button and the receiver will reboot. The receiver will emit a 2 second long beep indicating
memory is empty. This audio pattern will occur each time the receiver powers up until a remote ID number
is learned.
LEARN BUTTON