11
12
ITEM(S) NEEDED
#12 x 1
ad. Once the Splicers are secure on both wires, take the
Shrink Tubes and slide them over the Splicers. The
Shrink Tubes should be centered over the Splicer
and completely cover the wire connections.
Minn Kota Consumer & Technical Service
Johnson Outdoors Marine Electronics, Inc.
PO Box 8129
Mankato, MN 56001
121 Power Drive
Mankato, MN 56001
Phone (800) 227-6433
Fax (800) 527-4464
minnkotamotors.com
©2019 Johnson Outdoors Marine Electronics, Inc.
All rights reserved.
Part #2377118
Rev C
12/19
ECN 40131
For warranty information, please visit
.
11ad
11ae
Plug Assembly
Plug Assembly
Splice Cover
Shrink Tube
Positive Power
Lead (+)
Negative Power
Lead (-)
Negative (-)
Power Lead
Splicer
Splicer
Splicer
Shrink Tube
Shrink
Tube
Shrink
Tube
11ac
#6 x 1
ab. The Splicer and Shrink Tube should be added to the
Plug Receptacle so it can be attached to the Boat
Wires. Take the Plug Receptacle (Item #B) and place
one Shrink Tube (Item #6), followed by one Splicer
(Item #12) on the end of the black Negative (-)
Wire of the Plug Receptacle. Secure the Splicer by
tightening the Set Screw with a 3/32" Allen Wrench
to 20 in-lbs.
ac. Take the Plug Assembly and identify the red Positive
(+) Power Lead on the Plug Assembly and align
it with the Positive (+) Power Lead on the Trolling
Motor Wires. Insert it into the Splicer at the end of
the Positive (+) Lead Wire from the Plug Assembly.
Take the black Negative (-) Power Lead from the Plug
Assembly and align it with the Negative (-) Power
Lead from the Trolling Motor Wire. Insert it in the
Splicer at the end of the black Negative (-) Power
Lead of from the Trolling Motor Wires. Secure the Set
Screw of both Splicers with the Allen Wrench.
NOTICE:
The Shrink Tubes are meant to water
proof the connection between the Plug Receptacle
and the Boat Wires. Make sure there are no gaps
around the wires that would allow water to reach the
connection.
NOTICE:
When disconnecting the plug assembly
from the receptacle, be sure to install and tighten the
Dust Cap. This will prevent water or debris intrusion.
Plug
Assembly
Plug
Assembly
11ab
Positive (+)
Power Lead
Positive (+)
Power Lead
Negative (-)
Power Lead
Trolling
Motor Wires
ae. When satisfied with the position, secure the Shrink
Tubes in place with a Heat Gun. Then slide the
Splice Cover over the Shrink Tubes to complete the
installation.
NOTICE:
When connecting the plug assembly from
the receptacle, be sure to tighten the Threaded Collar to
ensure a proper water tight seal is achieved to protect
electrical contacts. Failure to tighten the Threaded Collar
could result in water intrusion.
Threaded
Collar