13
INSTALLING THE 17W LED ASSEMBLY
Step 1. Remove 1 of 3 screws from the light kit plate and loosen the other 2 screws. (do not remove)
Step 2.
While holding the 17W LED assembly under your fan, firmly snap the wire connection plugs together. (Fig. 14)
Step 3. Place the key holes from the 17W LED assembly over the 2 screws previously loosened from the light kit plate,
turn 17W LED assembly until it locks in place at the narrow section of the key holes. Secure by tightening the 2 screws
previously loosened and the one previously removed. (Fig. 24)
ATTENTION:
The Energy Policy Act of 2005 requires this fan to be equipped with a 190 watt limiting device. If lamping
exceeds 190 watts, the ceiling fan's light kit will shut off automatically.
FIG. 24
FIG. 25
INSTALLING THE GLASS SHADE
Raise the glass shade up against the light kit plate and secure the glass shade to the fan by turning the glass
shade clockwise until snug. DO NOT OVER TIGHTEN. (Fig. 25)
17W LED
ASSEMBLY
SCREW
GLASS SHADE
LIGHT KIT
PLATE
LIGHT KIT
PLATE
CONNECTION
PLUGS