OPERATING THE REMOTE CONTROL / WALL CONTROL
11
Remote Control only: Install a A23 12 volt battery (included). To prevent damage to transmitter remove the battery if not
used for long periods of time.
Your DC brushless motor is equipped with a self learning frequency function remote control.
Restore power to ceiling fan and test the transmitter as below for proper operation:
A. 1, 2, 3, 4, 5 and 6 button:
These six buttons are used to set the fan speed as follows:
1 = minimum speed
2 = low speed
3 = medium low speed
4 = medium speed
5 = medium high speed
6 = high speed
B. Reverse
button:
This button is used to change the direction of the rotation of the blades; forward for warm weather or reverse for cool
weather.
C. button:
This button turns the power Off to the Fan.
D. Button:
These buttons turn the light ON or OFF and also control the brightness settings of the light. The following instructions
apply to ceiling fans that feature a DOWN light.
( button) only or ceiling fans that feature an UP light ( button) and a DOWN light ( button) that are controlled
independent of each other;
Press and release the button for the desired light to turn the light ON or OFF. Press and hold the button to set the desired
light brightness. The light will cycle between bright and dim settings as long as the button is pressed. The light key has
an automatic auto-resume feature that allows the light to remain at the same brightness as the last time it was turned
off.