49
Chapter 7. Ordinary maintenance
EN
7.2. Problem solving
PROBLEM
CAUSE
SOLUTION
The pouch is not
sealed correctly
•
The sealing time is not correct.
•
The cover gasket (6) is dirty or worn.
•
The pouch is not placed correctly on the
sealing bar (5).
•
The sealing bar (5) is worn (the Teflon
coating is burnt).
•
The blade placed under the Teflon of the
sealing bar (5) is broken.
•
Change the sealing time.
•
Clean or replace the cover gasket (6)
(contact the Technical Assistance Service
for a replacement).
•
Position the pouch correctly.
•
Replace the sealing bar (5) (contact the
Technical Assistance Service for a
replacement).
•
Replace the sealing bar (5) (contact the
Technical Assistance Service for a
replacement).
Final vacuum is poor
•
The set vacuum percentage is incorrect.
•
The cover (6) gasket is dirty or worn.
•
The cover (6) is not closed correctly.
•
Impurities contained in the pump oil.
•
Change the vacuum percentage.
•
Clean or replace the cover gasket (6)
(contact the Technical Assistance Service
for a replacement).
•
Close the cover (6) correctly.
•
Make sure that objects or dirt are not
found between the cover (6) and tank (4).
•
Run a
“Oil Cleaning” (see par. 6.4) cycle
and check its quality. Contact the
Technical Assistance Service if it needs
replacing.
The cover (6) does
not open
•
No power supply.
•
Wait until the power supply is restored.
The cover (6) is
cracked or broken.
•
Damaged cover (6).
•
Replace the cover (6) (contact the
Technical Assistance Service for a
replacement).
If the machine does not work properly after the above-mentioned checks, contact the Assistance Service
describing the detected defect.
Summary of Contents for MX 2
Page 78: ...77 ...
