Revised 04/01/2016
Page 5
STEP 6
A. Attach the bracket (PB501026A) to the fender.
a. Drill six 5/16” holes through the
fender using the holes in bracket
PB501026A as a guide.
b. Install the 5/16” x 1” bolts through
the bracket and into the fender.
c. Use six 5/16” body washers and
5/16” nuts provided with the kit on
the underside of the fender.
d.
Tighten the bolts to
recommended torque of 10-15
FT-LBS.
Hand tightening with
Torque wrench is recommended.
DO NOT EXCEED
RECOMMENDED TORQUE
.
e. Make sure the fenders are square
and aligned (Figure 13). Twists or
bows in the fender will fatigue the
material over time.
STEP 7
A. For trucks with air suspension, raise and lower the suspension one final time to confirm
that there is adequate clearance between the fenders and wheels.
B. Recheck all brackets and bolts to ensure they are tightened to the recommended torque.
NOTE: ONCE FENDERS ARE IN SERVICE OCCASIONALLY CHECK TORQUE ON
5/8” X 4-1/2” HEX BOLTS IN THE FRAME TO MAKE SURE THEY DO NOT LOOSEN
OVER TIME.
Figure 13
Summary of Contents for B4850BTPACF
Page 6: ...Revised 04 01 2016 Page 6 ...
