Minimizer B4850BTPACF, Mounting Instructions

Page: 3 / 6

Revised 04/01/2016 Page 3
through. It is possible to remove any existing frame bolt and replace it with the
supplied bolt in the bracket kit.
Recommended torque for the 5/8 x 2-1/2” bolt
with washer is 110-115 ft-lbs
E. Install center bracket as close to the end of the fender as possible (Figure 6).
a. Drill three 5/16” holes through the fender using the holes in
bracket PB5069 as a guide.
b. Use three 5/16” x 1 ¼ ” bolts to bolt the center bracket and
fender together. Recommended torque for all 5/16”
hardware is 10-15 ft-lbs.
c. Use 5/16” body washers and 5/16” nuts provided with the kit
on the inside of the fender.
F. Some installations may not allow the center bracket to bolt through
the end of the fender.
a. In these cases use the plastic angle (PB5071) to connect the fender to the center
bracket assembly (Figure 7).
b. Use three 5/16” x 1” bolts, washers,
and nuts to bolt PB5071 to the center
bracket assembly. Do not tighten until
these until the fender is level.
Recommended torque is 10-15 ft-
lbs.
Tip: PB5071 is also used as a height
adjustment for the end of the fender.
G. Drill four 5/16” holes through the fender using the holes in bracket PB5071 as
a guide (Figure 8).
a. Install the 5/16” x 1 ¼ ” bolts through the bracket and into the fender.
b. Use 5/16” fender washers and 5/16” nuts provided with the kit on the
underside of the fender. Torque all 5/16” bolts to 10-15 ft-lbs.
Figure 5
Figure 6
Figure 7
Figure 8
See IMPORTANT assembly
instructions for center bracket
PB5069 & PB5067, last page
of this form.