MiniMax MM 16, Manual

Page: 7 / 34

6
WIDTHS:
Common blade widths are 1 1/4", 1", 3/4", 1/2", 3/8" ,1/4" , 1/8", 1/16"
You will find that 1", 1/2", 1/4" blades cover a wide range of woodworking tasks.
TEETH:
The number of teeth per inch of blade (TPI) will range from 3 TPI to as
high as 14 TPI. Rough work and very thick wood uses fewer TPI while narrower
widths and fine work use higher TPI.
TOOTH TYPE
: Hook/Skip type are good for re-sawing, ripping or joinery
BLADE TYPES :Blades can be had in carbon steel, Bi-metal or carbide tipped
blades. General woodworking needs can be met with a variety of types. Both
Carbon steel and Bimetal can be very effective. Carbide blades are a powerful
addition to resaw capability but must be suited to the saw.For example, the 1”
wide carbide blade offered by Mini Max is not recommended for the MM16
because the smaller wheel radius flexes and work hardens the blade leading to
premature breakage before dulling. A 1” Carbide is however very well suited and
effective on the MM20 and larger saws.
Note : Mini Max sells the Olson line of bandsaw blades. other options are offered
in our sources section.
GUIDE INSPECTION AND ADJUSTMENT
The guides are European ball-bearing type For very narrow width blades,
MiniMax is developing a “cool block” guide system for using 1/8" and smaller
blades
LOWER GUIDES
On the MM16 or MM20, remove the lower guides. (See Figure12 Lower Guides)
This is a good chance to check to see if the guides are cleaned of the Cosmoline!
Loosen the allen screws (in the back) that hold the guides to the aluminum
bracket. Align the guides and tighten the allen screws.
Back the guides off and then move them back together
to double check the adjustment before re-installing the
guides. While the guides
are out, sight them from
the top to make sure the
two guides are toed in
slightly towards the front.
(this is what makes them
spin and captures the
blade just behind the
gullets) If they are not,or the
guide wheels spin in opposite
directions when the saw is run with a blade installed, call the Austin Office to
report it and get instructions for a fix.
UPPER GUIDES
starting with the top guides ( See Figure 13 Upper Guides)
1).Screw the two side guides in and make sure they are meeting up
with each other like stacking coins. If they do not match up, loosen the
two allen screws from the back and then adjust (twist) the guides so