iCENTRAL MINICOM INSTALLATION MANUAL
9
DOOR STATION ADJUSTMENTS
There are 2 adjustments on the door station which may require fine tuning after
installation.
NOTE:
A flat bladed screw driver with a blade width of between 2mm and 2.4m is
required for these adjustments.
The use of an incorrect screw driver may result in the pot being damaged.
Speaker Volume
Speaker volume at the door station is adjusted by means of a miniature trim pot (VR1).
- See diagram below.
Turning this pot will vary the speaker volume.
This adjustment is best made while someone is communicating to the door station
from one of the internal stations.
Chime Volume
The chime volume is adjusted by means of a miniature trim pot (VR2).
- See diagram below.
Turning this pot will vary the chime volume throughout the entire system.
Before making an adjustment to this pot, adjust the slide volume control at each of the
internal stations so that communication can be heard at an acceptable level.
This door station pot (VR2) should then be adjusted so the chime comes through at an
acceptable level, at the internal room stations.
