Mini XQB25-725H, Instruction Manual

Page: 9 / 11

After press”POWER” button, press”PROGRAM ” button. Select the
washing program, and then press the program button for 3 seconds,
the lower right corner of the digital tube flashing. Preset program
start. Press the program button adjust the booking time, the initial
booking time of 1 hours, followed by 2 hours-3 hours-4 hours-5
hours-6 hours-8 hours-10 hours-12 hours-16 hours-20 hours-24
hours-No preset. Press”START/PAUSE”button start.
4
.
Adjust water level
The water level control uses the water level--frequency conversion way. The water level changes
the inductance of the vibration loop in the sensor, and changes the vibration frequency. When the
predetermined frequency is consistent with the water level, the water level reaches the setting
requirement and stops water inlet.
Press”Water level” button 1(little)-2(low)-3(medium)-4(high)
5
.
Press”START/PAUSE”button. system start.
Open the inlet valve, water enters the washing tub, when the water level reaches the set height,
water inlet stops. Pulsator begins to work, enter”washing”, then”rinse”and the”Spin”.The remaining
time of the process automatically minus 1 minute.
If user’s home water pressure is too low, the water inlet time is over 20 minutes, water have not
reach the set water level, digital display will show”E1" and alarm, Open and close the lid to resume
the water. In the drainage process, such as the drainage time of more than 5minutes, did not reach
the reset level, then stop drainage. digital display will show”E2"and alarm. Open and close the lid
to resume drainage. The”soaking”process and”washing” process have a water level detection, if the
water level is below the set limit, washing machine automatically recharge.
If the clothes are placed uneven before spinning, it is easy to result in bigger vibrancy of spinning.
The washing machine has a function of adjusting unbalance. When working, the system of the
washing machine always inspects running state. If finding a phenomenon that the spinning vibrancy
is too big, the washing machine automatically start the adjusting program to adjust the clothes state.
The washing machine can adjust unbalance twice, if no effect, the digital display will show”E4"and
alarm. Open the lid , and put the clothes balance, then close the lid, start”Spinning”.
Press the start/pause button in the running, system pause, the original flashing indicator light is
often bright, when press the button again, then resume the original working state.
In a standby power and water inlet and washing process, as detected by the water level sensor
abnormal frequency(frequency less than high limit water level or higher than the low water level
limit), turn off all output and buzzing alarm.
6
.
Washing machine automatically finish the whole process of laundry.
The remain time is”0", the buzzing informs 10 seconds after, The PC Board automatically power off.
Water
Level
Remaining Time (Min)
Preset Time (Hour)
Remaining Time (Min)
Preset Time (Hour)
Program/
Preset