Mini Pro Slot Car Dyno, Instruction Manual

Page: 17 / 21

16
Sequence Mode (Ex. Using Th. Controller Sensor for Servo and ESC)
TESTING MOTORS
1 2
3A
4
Connect the dyno to the PC using the micro-b USB ca-
ble, and connect the Throttle Controller Sensor to the
PC using the mini-b USB cable.
Input your Slot Car Settings
Click “Sequence Test Tab” following the Test number you would like the graph
NOTE: (2) two USB connection ports are required.
NOTE:
You can cancel the Sequence Test at any time by clicking the “STOP” button.
4.1. After you click “Start Sequence for
Test #1, 2 or 3” the test will begin.
4.2. You can modify the sequence
settings at any time by clicking “Edit”
4.3. Done!
CONT.
Open the Application, and
select the click “Connect.”
3.1. Click on “Settings Tab.”
3.2. Change the Tire Diameter, 1st Gear
Tranny Ratio, and Enable “Tires Connected
to Flywheel.”
3.3. Click “Save Settings.”
Note:
You should hear a “Beep”
sound if the ESC is powered.
Allows you to measure
Speed
Tire to Motor Turn Ratio
Slot Car Tire Diameter