14
Drawing2-16
（
3
）
Then click
Enter sweep time setting page
，
Then click
The "*" are switched to the second row
，
Rotation "ADJUST" knob to
adjust the sweep time, frequency arbitrarily set the time range between 1-600S, shown
in the lower set sweep time 10S:
（
4
）
Then click
Enter sweep mode selection screen shown in Figure
2-22, Click
Bond Select the frequency scan mode
。
There are two ways to scan
frequency, LINE (linear scanning) and LOG (logarithmic sweep).
（
5
）
After determining the scan mode
，
Click
Enter sweep control page
，
Then click
on or off sweep function.
11
、
Save / Load function
In the main interface, press
or
Enter the parameter to save the page, and
then click
Press the key combination of "*" consumption is adjusted to
the second row in Figure 2-11, then rotate "ADJUST" knob to adjust the save location,
this machine a total of 10 sets of parameters stored addresses M0-M9. Machine is
turned on by default to read M0 address parameters.