6
2. In power on mode, tap the POWER button to turn the unit off, the green power
button backlight turns off.
3.
At power-on mode 5V DC-OUT is turn on and ready for charging your cell phone.
4. At ON and Bluetooth mode the Bluetooth button back light flashes blue and red
alternatively.
Turn on the Bluetooth of your device to perform pairing in case it fails to linking
with the previously paired device.
Note:
Before first use, please charge the speakers for at least 4 hours because the
batteries may not fully charged, even though the charging LED lights.
BLUETOOTH OPERATION
Power on the unit and follow the directions below to use the A2DP profile Bluetooth
features of this unit.
Turn on the Bluetooth
At OFF mode , tap POWER button to turn the speaker on and its Bluetooth as well , the
Bluetooth button back light flashes red. It will start pairing with your Bluetooth device in 7
seconds. Blue and red flash alternatively when pairing is succeeded
At ON mode tap POWER button to shut down and tap again to turn on power and
Bluetooth. It will link with the previously paired device automatically.
Turn off the Bluetooth
In Bluetooth ON mode, press and hold the Bluetooth button and hold for about 5 seconds
until a beep sound is heard and the Bluetooth button backlight flashes one red and then
all lights go off.
Bluetooth will turn off automatically if linking was not processed or the link has been
interrupted for over 5 minutes.
PAIRING (LINKING) A BLUETOOTH ENABLED CELL PHONE OR OTHER
BLUETOOTH ENABLED DEVICE TO MICROBOX
1. Turn Power and Bluetooth on , it will beep twice , followed by alternative flashing of
blue and red lamp to indicate pairing completed.
2.
The unit is ready to pair (link) with your Bluetooth cell phone or device.
3. Turn on the Bluetooth feature of your cell phone and enable the search or scan feature
to find the " MICROBOX ".
4. Select " MICROBOX " from the device list when it appears on your screen. If required,
enter the pass code “0000” to pair (link) the unit with your cell phone.
