10
11
Assembly
Connecting the Coil Cable:
1 Wind the coil cable around the lower and upper
shafts enough times to take up the slack. Leave
enough slack at the bottom of the cable near the
coil to allow the angle of the coil to be adjusted
while detecting.
2 Use the velcro straps to secure the coil cable to
the shaft.
3 Plug the coil connector into the coil socket on the
control box, firmly tightening the retaining ring to
hold it in place.
Attaching the Armrest Strap to the Armrest:
1 Press both strap studs onto the armrest studs.
2 Push the armrest straps through the slots in
the armrest cover and then slide the cover
over the armrest.
Connecting the Control Box to the Upper Shaft:
1 Place the detector on a flat surface, with the
handle facing upwards.
2 Position the armrest on top of the control box.
3 Clip the control box onto the armrest, ensuring
the battery plug faces away from the coil.
4 Fasten with the wing-nuts.
5 Wind the Quick-Trak button cable around the
upper shaft and plug it into the Smart Point
socket in the control box. Ensure that the cable is
wrapped firmly but avoid strain on the connector.
Always ensure that the control box is turned
off before connecting or disconnecting the coil
to avoid damage to the detector's electronics.
Note: If the Quick-Trak
cable becomes loose try
securing it onto the shaft
with electrical tape.
Summary of Contents for GPX-4500
Page 6: ...6 7 List of Parts...
