Minelab GPX-4500, Instruction Manual

Page: 7 / 55

8 9
Attaching the Coil to the Lower Shaft:
1 Plug the two rubber washers into the holes on
either side of the lower shaft.
2 Ensure that the spring loaded pin of the lower
shaft is pointing downwards. Slide the lower shaft
into the bracket on top of the coil.
3 Insert the bolt through the lower shaft and the
bracket on top of the coil. Fasten with the nut
provided; being careful not to damage the thread
of the nut by over-tightening. This may need to
be loosened to adjust the coil to a comfortable
detecting angle.
Note: If the coil becomes loose over time the rubber
washers may need replacing.
Assembly
Attaching the Lower Shaft to the Upper Shaft:
1 Rotate the twistlock of the upper shaft counter-
clockwise to ensure it is loosened.
2 Compress the spring loaded pin of the lower shaft.
Slide the lower shaft into the upper shaft until the pin
reaches an adjustment hole. The pin will spring out
and clip into place.
3 Rotate the twistlock clockwise to clamp the lower
shaft and prevent movement.
Attaching the Handle to the Upper Shaft:
1 Slide the bungy cord clamp onto the upper shaft.
2 Slide the handle onto the upper shaft so it slopes
away from you, as seen below.
Attaching the Armrest to the Upper Shaft:
1 Place the two armrest halves on either side of
the upper shaft, aligning the armrest and upper
shaft holes.
2 Insert the bolts through the armrest and upper
shaft holes.
3 Loosely fasten the wing-nuts onto the bolts (these
will be tightened after the control box is attached).
spring loaded pin
The Coil cable is directly wired into the coil and
is not removable. Any attempt to disconnect
this cable will void your warranty