Minebea Intec Maxxis 5 Phase PR 5900/81, Operating Instructions Manual

Page: 32 / 94

Note:
The value of the digital input is not written to the SPM if the address = 0 (inactive).
5.4.3 Coniguring outputs
This function is required to conigure the analog and digital outputs.
- Analog output, see Chapter 5.4.3.1 .
- Adapting the analog output, see PR 5900 operating instructions.
- Digital inputs, see Chapter 5.4.3.3 .
- I/O cards test, see PR 5900 operating instructions.
When changing the I/O card type, the coniguration data remains unchanged. Functions
for a non-installed scale can be selected, however, they are without efect.
The free and assigned SPM addresses are documented in Chapter
8 .
The assignment of SPM addresses to a scale is only valid if the scale exists.
Non-allocated outputs are switched of.
The card type and the available inputs and outputs are detected automatically.
Configuration @admin
Inputs
Outputs
Modbus-TCP master
Limits
Parameters
Production lines
Local control
Overview weighing points
View weighing point
Simulation
Print
10. Conigure inputs 3+4 in the same way.
11. Press the [Default] soft key to return to the factory settings, if required.
12. Finally, press the [Save] soft key to save the settings.
In the operating menu, select and conirm [Coniguration] - [Outputs].
Phase PR 5900/81 5 Getting started
EN-30 Minebea Intec