Minebea Intec CSD-918 Series, Operating Instructions Manual

Page: 49 / 240

Note:
-
The actual weighing value displayed on pitch conirmation screen is a
corresponding value to each registered A/D count value in the registered content
from zero to SPAN.
- When the registered contents from zero to SPAN are switched, the actual weighing
value displayed is switched also.
6.5.1 Switch to registration and conirmation screen of pitch
You can switch from weighing screen to registration screen of pitch conirmed by the
following operations.
6.5.2 Registration and conirmation method of pitch
After the stability of pitch conirmation and registration screen lights.
You can register up to six points of pitch.
After registration is completed.
6.5.3 Pitch conirm method
After conirmation.
6.6 Digital linearization (DIGITAL LINEARISE)
After the calibration, weighing error of some scale intervals between the zero and SPAN
(max. load) might occurs due to the inluence of load cell.
The digital linearization is a function to execute the compensation for up to 3 points
except for zero and SPAN, and to reduce the weighing error.
1. Select [MENU].
2. Select [CALIBRATION] on menu screen 1/2.
3. Select [PITCH CONFIRMATION SET] on load calibration screen 2/2.
4. The message of [Has zero calibration completed?] is appeared. Tap [YES].
1. Please put the weight to be registered on weighing section.
2. Tap [READ] whose number you want to register with.
The message of [Other than the SPAN point?] is appeared.
3. Tap [YES].
The registered value is conirmed.
4. Tap [OK].
5. Please repeat the operation of Step 1 to Step 4 when there are two or more points of
pitch.
6. Tap [BACK] to load calibration screen.
1. Select [PITCH CONFIRMATION] on weighing calibration screen 1/2.
The list of the registered weighing value actually is displayed in the number
section where registration was executed in Chapter 6.5.2 .
2. Tap [BACK] to return to weighing calibration screen.
6 Calibration Weight Controller CSD-918
Minebea Intec EN-47