Minebea Intec CSD-918 Series, Operating Instructions Manual

Page: 135 / 240

Note:
-
Only during the measurement mode, the serial data is output.
- The data of serial interface stops to output when the maximum display is set to six
digits. Set the maximum display digit within ive digits when you use the data of
serial interface.
- Refer to Chapter 4.7 .
15.3 Explanation of format data
- Automatic print bit [FUN1: bit 0]
This bit can be used as a trigger at receiving side of the instrument with 2-pin method
serial interface.
- Display bit [ST1:bit 7, bit 6]
Bit 7: Put [1] when the display of the instrument is gross weight.
Bit 6: Put [1] when the display of the instrument is net weight.
15.4 Explanation of output type
- Stream mode
The data of gross weight, net weight, etc., keeps outputting in constant intervals.
- Print mode
In the print mode, there are 3 print signal operations, that is, [SYNC. WITH PRINT],
[SYNC.WITH ACCUM] and [SYNC.WITH FIHISH].
When each external control input of [Print signal], [Accumulation signal] and [Finish
signal] are input, [1] is put to FUN1 of output format for automatic print bit.
Refer to Chapter
15.5 .
15.5 Switch to print signal operation screen (OPERATION OF PRINT)
15.6 Changeable item of Print signal operation
The set of print signal operation is selectable from [NOTHING], [SYNC.WITH PRINT],
[SYNC.WITH ACCUM] or [SYNC. WITH FIHISH].
When the setting of [SYNC. WITH PRINT] is selected, the data is transmitted after putting
[1] to FUN1 of output format for automatic print bit when [Print command] is input from
the external control output, etc.
When the setting of [SYNC. WITH ACCUM] is selected, the data is transmitted after
putting [1] to FUN1 of output format for automatic print bit either when [Accumulation
command] is input from external command I/O, etc., or when automatic accumulation is
in work.
1. Select [MENU].
2. Select [BUILT-IN SERIAL I/F] in the menu screen 1/2.
3. Select [S I/F] in the standard communication setting screen.
4. Select [OPERATION OF PRINT] in the Serial interface screen.
15 2-pin method serial interface (S-I/F) Weight Controller CSD-918
Minebea Intec EN-133