2. Install the Main Unit
4. Install the CO2 Absorbent Canister
3. Install the Breathing Circuit (Veta 5 Only)
1. Install the Trolley
Main unit
supporting
board
Veta 3/Veta 5 Installation Guide
Insert the column into the trolley base; then, put the trolley down and tighten the screws.
Lock four casters of the trolley. Then, place the main unit securely on the trolley by aligning
three positioning columns under the main unit with three locating pins on the trolley, and
tighten screws.
a. Align the guiding post slots of the breathing system with the guiding post of the main unit
circuit connector, and fix the breathing circuit with screws.
b. Fix the fastener under the supporting board and insert the inner hexagon spanner into it.
c. Insert the microswitch cable plug into the slot.
Rotate the CO2 absorbent canister counterclockwise to fix it.
5. Install the Bellows (Veta 5 Only)
Tools：
●
M8X25 screws：4
●
Inner hexagon spanner
Column
Tools：
●
M8X25 screws：4
●
Inner hexagon spanner
Positioning column
Microswitch
cable plug
Screws
Screws
Screws
Check the
connector for
absorbent
particles.
6. Install the Basket
Hang the basket on the handrail of the machine directly or install it on the column.
Screws
Inner hexagon spanner
a. Attach the bottom ring of the bellows to the bellows base and ensure that the bellows is
tightly connected to the base.
b. Align the bellows housing bayonet with the slots, and rotate it clockwise firmly.
Tools：
●
M8X25 screws：3
●
Inner hexagon spanner
Tools：
●
M4X12 screws：4
●
Phillips screwdriver
