Mindray iMEC10, Service Manual

Page: 12 / 148

1-2
1.1.1 Dangers
There are no dangers that refer to the product in general. Specific “Danger” statements may be given in the respective
sections of this manual.
1.1.2 Warnings
WARNING

All installation operations, expansions, changes, modifications and repairs of this product are conducted
by Mindray authorized personnel.

There is high voltage inside the equipment. Never disassemble the equipment before it is disconnected
from the AC power source or the battery.

When you disassemble/reassemble a parameter module, a patient leakage current test must be performed
before it is used again for monitoring.

The equipment must be connected to a properly installed power outlet with protective earth contacts
only. If the installation does not provide for a protective earth conductor, disconnect it from the power line
and operate it on battery power, if possible.

Disposal of the packaging material should observe the applicable waste control regulations. and keeping
it out of children’s reach.
1.1.3 Cautions
CAUTION

Make sure that no electromagnetic radiation interferes with the performance of the equipment when
preparing to carry out performance tests. Mobile phone, X-ray equipment or MRI devices are a possible
source of interference as they may emit higher levels of electromagnetic radiation.

Before connecting the receiver to the power line, check that the voltage and frequency ratings of the
power line are the same as those indicated on the unit’s label or in this manual.

Protect the equipment from damage caused by drop, impact, strong vibration or other mechanical force
during servicing.
1.1.4 Notes
NOTE

Refer to Operation Manual for detailed operation and other information.
1.2 Equipment Symbols
See the iMec series Operator’s Manual for information about the symbols used on this product and its packaging.