Mindray ePM 10M, Operator'S Manual

Page: 310 / 364

B - 4
WARNING
•
The device is configured with a wireless network connector to receive wireless signal. Other devices
may interfere with this device even though they meet the requirements of CISPR.
B.2 Radio Regulatory Compliance
The radio device used in this product is in compliance with the essential requirements and other relevant
provisions of Directive 2014/53/EU.
This device complies with part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is subject to
the condition that this device does not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired operation.
WARNING
•
Changes or modifications not expressly approved by the party responsible compliance could void
the user’s authority to operate the equipment.
Recommended separation distances between portable and mobile RF communications equipment and the device
The device is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled. The
customer or the user of the device can help prevent electromagnetic interference by maintaining a minimum distance
between portable and mobile RF communications equipment (transmitters) and the device as recommended below,
according to the maximum output power of the communications equipment.
Rated maximum
output power of
transmitter (W)
Separation distance in meters (m) according to frequency of the transmitter
150 kHz to 80 MHz 80 MHz to 800 MHz 800 MHz to 2.7 GHz
0.01 0.12 0.12 0.23
0.1 0.38 0.38 0.73
1 1.20 1.20 2.30
10 3.80 3.80 7.30
100 12.00 12.00 23.00
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in metres
(m) can be estimated using the equation applicable to the frequency of the transmitter, where P is the maximum output
power rating of the transmitter in watts (W) according to the transmitter manufacturer.
Note 1:
At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
Note 2:
These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and
reflection from structures, objects and people.
d 1.2 P = d 1.2 P = d 2.3 P =