These guidelines do
NOT
replace the instructions for use and all users should refer to the appropriate
Operator’s Manual
for detailed instructions.
The Illustrations may not necessarily reflect the setup or data displayed on your device.
CAS BeneVision N Series 22/19 & N1 User Guide_V1 Mindray UK © 2020. Errors and omissions excepted. Subject to change.
Mindray® is a registered trademark of Shenzhen Mindray Bio-Medical Electronics Co. Ltd.
1
BeneVision N Series 22/19
N1
SAFETY
Safety checks
•
General overview of system integrity, system is visually clean, all required accessories are available and
suitable for patient group
•
Check integrity of accessories, ensure mains lead is plugged in and that mains power is on
Disabling the touchscreen
•
Press and hold the Main Menu quick key for approx 5 seconds. A padlock symbol
displays above the main
menu quick key if the touchscreen is disabled
•
The touchscreen lock period is configurable. To do so, follow this procedure:
Access Display by either of the following ways:
▪
Select the Screen Setup quick key
→
select the Display
▪
Select the Main Menu quick key
→
from the Display column select Display
▪
Set Screen Lock Duration
•
To re-enable the touchscreen, press and hold the Main Menu quick key again
Cleaning
•
Adhere to the Operators Manual for advice on cleaning agents
•
Follow hospital policy, but with an awareness that agents utilised by the hospital may cause damage to the
monitor over time
Please Note:
Some items that connect to the system are single patient use
N1
Removing & inserting the N1
•
Press the tab located on the underside of the N1 module and remove from the module housing
•
Insert the N1 by sliding the module into the housing until a click is heard
•
The monitored parameter waveforms appear on the host monitor screen
•
Two green LEDs are illuminated on the front of the N1 module
N1 battery
•
Up to 8 hours within optimal conditions (powered by a new, fully charged battery at 25
◦
c, ECG, SpO
2
, auto NIBP
measurements @15 min intervals)
•
Battery life reduced to approximately 3 hours when using N1 and transfer CO
2
unit under the conditions
stated above
N1 storage
•
Ensure the N1 is docked. When the host monitor is connected to AC mains power and in Standby, the N1 will
receive a battery charge
•
If the host monitor is switched off and connected to AC mains power, only the host monitor receives a
battery charge
