7
Introduction to installation
Note: If any of the below operation is incorrect, turn off the power immediately and check the scanner for
any improper connections. Go through all steps again.
Installation - keyboard wedge
1.
Switch off the host and unplug the keyboard connector.
2.
Connect the round male DIN host connector of the Y-cable to the keyboard port on the host device.
3.
Connect the round female DIN keyboard connector of the Y-cable to the keyboard.
4.
Ensure that all connections are secure.
5.
Switch on the host system.
Figure 2
Installation - RS-232
1.
Connect the other end of the interface cable to the serial port on the host. Tighten the two screws
to secure the connector to the port.
2.
If the host does not have power supply (on PIN 9), connect the external power supply (DC adapter)
to the RS-232 cable.
Figure 3
Summary of Contents for MD52 Series
